Selve Commeo Send WS 10 handheld transmitter with 10 channels and sun and wind functions

SelveCommeo Send WS 10 handheld transmitter with sun and wind functions

Selve Commeo Send WS 10 bidirectional handheld transmitter with 10 channels, featuring a slide switch for easily disabling automatic central commands. This transmitter can also be used to set the threshold values for sun and wind in the Commeo Sensor WS or WSRF.

 - Frequency 868 MHz
 - SELVE bidirectional radio technology
 - 10-channel Transmitter
 - Button for disabling automatic central commands
 - Setting threshold values for sun and wind sensors
 - now only available in white
 - successor to the Selve Iveo Send 5 and 10-channel Transmitter
 - Receiver feedback via reading of the radio signal
 - Greater range through ‘hopping’ (repeating) of the control command where necessary
 - resistant to interference and eavesdropping thanks to a fast radio protocol and rolling code technology
 - Dimensions: 42 x 133 mm
 - Battery: 2 x AAA
 - Supplied with batteries and wall bracket

Programming a new handheld transmitter if the original is faulty or missing

 - Disconnect the power supply for 3 seconds
 - Reconnect the power supply for 3 seconds
 - Disconnect the power supply for 3 seconds
 - Connect the power supply
 - Press and hold the PROG button on the Transmitter for 3 seconds
 - all old transmitters/channels have been deleted and the new transmitter
   has been programmed

Programming additional handheld transmitters/channels

 - Press and hold the PROG button on a remote control that is already working
   Handheld transmitter; it will confirm this by briefly opening and closing.
 - The receiver will remain in programming mode for 1 minute
 - Briefly press (for 1 second) the PROG button on the new remote control
   or the new channel
 - The new Transmitter or the new channel is now programmed